As Me Made May approached this year, I was reminded of the deficit of options for my lower half that I noticed last year.
I bought fabric for two pairs of jeans over a year ago, but I’ve been intimidated by the complexity of jeans design so it took me a while to find the nerve to cut my pants out. The fabric is 11.5 oz stretch denim from StyleMaker Fabrics. I (once again) riffed on the Cigarette Pants pattern from Gertie Sews Vintage Casual.
I started these jeans in December, got the fronts and backs assembled (including the zipper, which was intimidating and very puzzling), then realized that jeans need top-stitching, and put them away for a while.
A couple months later I pulled the jeans out of their hiding place and did all the top-stitching all at once, even though that was very much not the order it was supposed to be done in (and doing it out of order made it more difficult). Ideally I think you would want to sew jeans with two machines side by side: one to sew the seams with thread that matches your fabric, and one to top-stitch the seams with heavy jeans thread. That way you would save time and avoid the need to rethread your machine after every seam.
I am very pleased with the stitching on the pockets. I free-handed my design with chalk and was so pleased with the first pocket. Since it is a simple design I was able to replicate it on the second pocket pretty closely. Then I ironed the edges in and positioned them on the pants using the highly scientific method of holding the back up to myself, then putting my hand where I expected a pocket to be. I checked the position visually, made some adjustments, then did my best to mirror the position for the second pocket. I waited to sew the pockets on until I was convinced the position was correct for both.
With the fronts and backs assembled, it was time to sew the inseam. I sewed the seam and top-stitched it. Then I did a fitting to make sure the side seams fit well, and top-stitched the top 8 inches or so. This was a mostly uneventful process, but the lower leg is a little bit skewed because I needed to narrow the leg, but I didn’t want to undo my top-stitching. It is unnoticeable in the final garment unless you’re really looking for it.
Next I added the waistband. I cut a strip on the straight grain for a 1” waistband. As usual, I sewed the waistband onto the front of the pants, folded the raw edge under, and top-stitched around it with jeans thread. Then I did a machine buttonhole and added a jeans button. I accidentally snipped several of the buttonhole threads when I cut open the buttonhole, so I went over the buttonhole again by hand. I also had trouble with the jeans button and ended up needing to replace it. There is definitely some technique involved when securing a jeans buttonhole. Finally, I hemmed the pants to length, and they were done.
This was my first time making rigid pants, and the fit is very different than you get with a stretch denim or a ponte knit. But once I got past that difference, I found the pants to be pretty comfortable. I am so proud of myself for making these! There are definitely more me-made jeans in my future.
Dramatic Lyric 